PARSON
CA LINER 100+

Calcium Aluminate lining designed to protect new and existing structures against H2S attack.

DESCRIPTION:
PARSON CA LINER 100+ is a high strength, pure fused Calcium Aluminate Cement and Calcium Aluminate aggregate mortar designed to rehabilitate and protect new and existing manholes, wet wells, lift stations and other Wastewater related structures against H2S attack.

ADVANTAGES:

Cost-effective alternative to replacement
Stops infiltration and exfiltration
Restores strucural integrity
Provides a high level of corrosion protection
High early and 28 day strengths
Freeze-thaw resistant
Low Permeability
Excellent Bond to damp surfaces
Apply up to 2" in a single coat
Spincast, Spray Gun or trowel application

CA Liner 100 can be spray applied to rehabilitate manholes and other deteriorated sewage structures.

Application Equipment for Manhole Rehabilitation Products

PHYSICAL PROPERTIES:

Compressive Strength
ASTM C-109

Flexural Strength
ASTM C-293

Tensile Strength
ASTM C-190

Shear Bond
ASTM C-882

Density

24 hours 6,000 psi
28 days > 9,000 psi

24 hours 1,400 psi
28 days > 1,600 psi

28 days > 800 psi

>2,400 psi

150 pcf

Shrinkage ASTM C-157

Freeze/Thaw ASTM C-666

Chloride Permeability
AASHTO T-277

Sulfide Resistance ASTM C-267

0.0% (at 90% RH)

300 cycles, No damage

< 300 coulombs (very low)

No weight loss after 90 days in 20,000 ppm aqueous sulfuric acid solution.

SURFACE PREPARATION: Thoroughly clean and remove any loose or foreign materials including paints, dirt, oil, grease, surface coatings, laitance and any other bond-inhibiting material from surface to be coated, using minimum 3500 psi waterblast. Stop all active leaks. (Please refer to our Manhole Rehabilitation Specifications for product selections.) Surface should be Saturated Surface Dry (SSD) just prior to material application. Any standing water must be removed. Please refer to our Specifications for Manhole Rehabilitation for product selections.

MIXING: Using a slow-speed mortar mixer or large mechanical jiffy mixer, add approximately 3/4 gallon of clean, potable water per 50 lb. bag of PARSON CA LINER 100+. Add water to mixer and then add powder. Mix thoroughly for approximately 3 minutes until a uniform consistency has been obtained.

APPLICATION: Using low pressure spray equipment or trowel, apply mixed product on vertical, horizontal and overhead surfaces to a minimum thickness of ½". Trowel or brush to a smooth finish as soon as possible, but within one hour. If additional material is required, apply up to 2” of product within 2-3 hours, then trowel or brush to a smooth finish as soon as possible, but within one hour. Do not apply to frozen surfaces. As temperatures rise above 80º F, the working and cure times will decrease. Conversely, working and cure times will increase as temperatures fall below 65º F. Equipment and hoses should be cleaned frequently of residual material.

Click to watch application video

COVERAGE: Approximately 10 sq. feet per 50 lb. bag at a thickness of 1/2 inch.

PACKAGING: Available in 50 lb. multiwall paper bags with moisture barrier.

STORAGE: Shelf life is 2 years when stored at 70°F in unopened, tightly sealed bags in a dry area.

PRECAUTIONS: See MSDS for specific instructions. Use protective eye wear, cover exposed skin and use breathing protection.