PRIME FAST

A penetrating polyester primer to enhance coating adhesion

DESCRIPTION: Parson Prime Fast is a specially formulated polymer primer that will penetrate concrete substrates.

ADVANTAGES:

Ultra low viscosity will penetrate concrete for permanent bond.
Will not harden or become brittle.
Good chemical resistance.
Minimum surface preparation required.
Self-leveling in thinner viscosities.
Will not shrink.

SURFACE PREPARATION: Thoroughly clean and remove any loose or foreign materials including paints, dirt, oil, grease, surface coatings, laitance and any other bond-inhibiting material from surface to be coated, using minimum 3500 psi waterblast. Stop all active leaks. Please refer to general Specifications for product selections. Surface should be Saturated Surface Dry (SSD) just prior to material application. Any standing water must be removed.

PACKAGING: Ten Gallon Kit: 5 gallons of 'A' side and 5 gallons of 'B' side.

MIXING: One component, no mixing required.

APPLICATION RECOMMENDATIONS: Spray apply 1-2 mils using household garden sprayer. Allow 20-30 minutes prior to application of Parson FlexLiner 1000.

SHELF LIFE: One year, in original, unopened factory containers, under normal storage conditions of 55ºF to 95ºF.

SAFETY: Not R.C.R.A. or DOT regulated. Read Material Safety Data Sheet before using. Seal container tightly after use to prevent introduction of moisture laden air.