MANHOLE & WATER
VALVE BOX INSERTS

Plastic Manhole Insert
Manhole Insert- V2P
Stainless Steel Insert
Valve Box Insert
Odoreater Insert
Inflow Cost Analysis

MANHOLE REHAB
PRODUCTS

MANHOLE REHAB
APPLICATION EQUIPMENT

MANHOLE CHIMNEY
& JOINT SEALANTS

MANHOLE ODOR CONTROL

VOLUMETRIC WEIRS

PAVING RISERS

ADDITIONAL PRODUCTS
Rap-O Manhole Cover Cushion
Manhole Cover Extractor
Manhole Lid Puller
Manhole Steps

ENGINEERING SPECS


PARSON
QUICK PLUG

Just mix with water and watch it work


DESCRIPTION:
PARSON QUICK PLUG is a hydraulic cement material that is mixed with clean, potable water to produce an extremely rapid setting plug. It is inserted into prepared areas to stop leaks under pressure. PARSON QUICK PLUG may also be used for repairing cracks in concrete or mortar. It is ideal for sealing around pipes and conduits, and for setting anchor bolts and railings. It is non-corrosive and produces extremely high strengths.

ADVANTAGES:
  • Simple to use - Just add clean, potable water.
  • Stops leaks in approximately 1 minute!
  • Fills holes & cracks in floors and walls, etc.
  • Excellent freeze-thaw resistance (procedure ASTM C-157)
  • Nonmetallic
  • High early strength
COMPRESSIVE STRENGTH
(ASTM C-109)
15 minutes.........750 psi
1 day...............3,700 psi
7 days.............4,400 psi
28 days...........5,500 psi

1.  Cut out the area to be plugged to minimum depth and width of 1".  Clean with high pressure water blast to remove oil, grease, loose mortar, paints, coatings, etc.   2.  To mix, add enough clean water to QUICK PLUG to make putty consistency. (4:1 cement/water ratio)
3.  Work putty between hands, into a ball-shaped mass until it begins to stiffen.   4.  Force QUICK PLUG into opening with hand or trowel. Hold for approximately 1 minute or until material has set.

PRECAUTIONS: The setting time of PARSON QUICK PLUG will vary according to ambient and surface temperatures. To hasten set time, use heated mixing water. The dry powder material may also be heated up to 100°F. Cool water or ice should be used to prevent extremely rapid set. Do not add any other cements or aggregates to PARSON QUICK PLUG.

SAFETY: PARSON QUICK PLUG contains ingredients that will cause irritation and burns to sensitive skin and eyes. Wear protective glasses and rubber gloves. If product is splashed into eyes, wash immediately with clean water and consult a physician.

STORAGE: Shelf life is 9 months.  Keep PARSON QUICK PLUG dry and at room temperature with the container tightly closed.

PACKAGING: PARSON QUICK PLUG is available in 5 gallon pails containing 50 lbs. of material.

COVERAGE: Approximately 17 cu. inches per lb.        *50 lbs. = 850 cu. inches
1 lb. PARSON QUICK PLUG will fill an opening approximately 1.45 ft. long by 1" wide and 1" deep.

MATERIAL:
The cement shall meet the following requirements:

Set time
Sulfate Resistance, Passed
Freeze-Thaw Resistance, Passed
Shrinkage/Expansion
Pull Out Strength, lbs.

60 seconds
25 Cycles Min.
62 Cycles
+ 0.02
12,000 lbs.
ASTM C-191
ASTM C-88

ASTM C-157
ASTM C-234
(4# bar imbedded 6 inches in a cement pocket of 1.5 in. diameter)

BACK TO TOP